Pages
Categories
Archives
- March 2012
- February 2012
- January 2012
- December 2011
- November 2011
- October 2011
- September 2011
- August 2011
- July 2011
- June 2011
- May 2011
- April 2011
- March 2011
- February 2011
- January 2011
- December 2010
- November 2010
- October 2010
- September 2010
- August 2010
- July 2010
- June 2010
- May 2010
- April 2010
- March 2010
- February 2010
- January 2010
- December 2009
- November 2009
- October 2009
- September 2009
- August 2009
- July 2009
- June 2009
- March 2009
- February 2009
- January 2009
- December 2008
- November 2008
- October 2008
- September 2008
- August 2008
- July 2008
- June 2008
- May 2008
- April 2008
- March 2008
- February 2008
- January 2008
- December 2007
- November 2007
- October 2007
- September 2007
- August 2007
- July 2007
- June 2007
- May 2007
- April 2007
- March 2007
- February 2007
- January 2007
- December 2006
- November 2006
- October 2006
- September 2006
- August 2006
- July 2006
Meta
12th 2007f February 2007
Posted in: Uncategorized
Anirudh J asked:
I bought new Insignia speakers for my laptop. The speakers do not have an ac power cord. The back has red and black switch like clips to hold the positive and negative cords. I need to connect these with my hp dv6000 laptop. how should i go about it?
I cut open the creative headphones wire but it has 3 wires..red green and copper.. whihc one is neagative and whihc is positive?
Ivan
I bought new Insignia speakers for my laptop. The speakers do not have an ac power cord. The back has red and black switch like clips to hold the positive and negative cords. I need to connect these with my hp dv6000 laptop. how should i go about it?
I cut open the creative headphones wire but it has 3 wires..red green and copper.. whihc one is neagative and whihc is positive?
Ivan
1 Comment
RSS feed for comments on this post.
Sorry, the comment form is closed at this time.
You need to splice together a wiring harness - which is easy to do!
1) grab an old set of headphones. Cut off the ear buds & strip 1/2 inch of the plastic coating on each wire. One of the wires will have writing on it, use that as your negative wire.
2) plug it into the headphone jack on your laptop, connect the 2 wires to the first speaker. It should work.
3) To connect the 2nd speaker, get another length of speaker wire, strip the plastic of of both ends
4) connect one end into your first speaker & the other end onto the 2nd speaker making sure the wire connects the positive (red) clip of the 1st to the red clip of the 2nd & then connect black to black.
Done!
Your speakers will work fine, but you can get them louder by connecting them via an amp…
Comment by JustMe — February 14, 2007 @ 8:55 am